I think, after a year break it is time to start posting about wedding crafts. Since crafting is my hobby anyhow, having a DIY wedding was not only the obvious choice, but was no extra work. I simply replaced my personal crafting time with my wedding crafts. These crafts were more redundant than previously, but I had a bit more motivation to work hard, so it balanced out in the end.
Materials:Light colored Paper about 1 page/2 flowers (anything less heavy than cardstock, but more heavy than copy paper will do). I used cream
Dark colored Cardstock Paper (I actually used the paper kids make school projects on because it was the only navy paper I could find). The heavier the better
Hot glue or white glue (I used both)
Pliers (or just a pencil will do)
What I did:
I actually followed This tutorial on the Elli blog and made a few of my own variations. She called them roses, but I chose them because I thought they looked like poppies which is what I was going for.
Cut out TONS of petals in the shape of the picture to the right.. Cut them free hand because you do not want them to all be the same. Vary width, height, and shape if you like. I folded my paper in half and cut two petals at one time. Cut three small slits in the bottom just like the black lines on the picture. Fold the sides over the middle and glue them in place (this is later referred to as the platform). The petal should start to form a curvichure when you do this. I used white glue for this so there was no bump.
Once the glue on the petals has dried it is time to start to put them together. Start with 3 or 4 of your smaller petals. Arrange them in a circle and use white glue to glue the platforms together one on top of another. Use another 5-4 of your larger petals and glue their platforms underneath. Make sure to stager the petals when you arrange the outer ones so that they are between the inner petals. Continue adding petals staggered to the outside until you are pleased. I used about 6-10 petals/ flower depending on the shape and size.
Next cut 1.5" and 2.5" diameter circles out of the dark paper. Cut slits in the circles from the outside edge to the centre as thin as you can go (mine were about 2mm). The slits should go 3/4 of the way to the centre. so there is a small uncut spot in the middle. Curl the slits around a pencil or chopstick so they resemble a small bowl. Finally glue the smaller one inside the bigger one. This will be the centre of your flower.
Twist the top of your floral wire 1-2 times around your pliers or pencil and fold that section over so that it creates a platform. Hot glue the flower petals onto the platform. Then use hot glue to place the centre piece inside the newly assembled flower. Finally cut a small cloud shape out of your lighter paper (the same as the petals). Poke a hole in the centre with the floral wire and slide it up the floral wire and hot glue it onto the very bottom to cover up the floral wire platform.